Woods BACKHOE 1050 Operator's Manual download pdf (Page 65)

12.14.5. Replace front cover and secure using Hex Bolt

1/4"-20NC x 1" Grade 5, Lockwasher, and Flatwasher,

2 places each side. Replace valve cover plate

assembly and secure using Hex Bolt 1/4"-20NC x 1"

Grade 5, Lockwasher, and Flatwasher,

1 place each side.

Hex Bolt 1/4"-20NC x 1" Grade 5,

Lockwasher, and Flatwasher,

2 places each side

Hex Bolt 1/4"-20NC x 1" Grade 5,

Lockwasher, and Flatwasher,

1 place each side

12.14.6. SWING CYLINDER INITIAL OPERATION: Operate swing cylinder fully right and left at a slow speed.

This will insure that cylinder is full of oil and orifices are working properly.

12.15. Swing Chain Service

12.15.1. Lubricate the chain when it appears to be dry.

Use a high grade of chain lubricant when servicing.

12.16. Swing Chain Adjustment and Service Instructions

12.16.1. When you first receive backhoe, and periodically thereafter, it will be necessary to adjust the swing

chains. Keeping swing chains in proper adjustment will allow backhoe to swing the same distance from right and

left and will keep from voiding warranty.

12.16.2. Secure

swing cylinder by

installing swing

transport locking

pin. Adjust swing

chain by loosening

or tightened 3/4"

locknut until

measurements from

the cylinder tube

end and the

backhoe end plate

are the same from

right hand and left

hand sides. This

will allow backhoe

to swing the same

distance right and

left.

Position Bolt

Head Upward in

Upper Chain, 2

places. Torque

to 54 ft. lbs.

max.

Chain Bolt.

Flatwasher 3/4"

Hardened.

Hex Nut 3/4"-

10NC Nylon

Lock.

Position Bolt

Head Downward

in Lower Chain,

2 places.

Backhoe End

Plate.

Measurements for RH and

LH sides must be the same.

Cylinder Tube

End.

IMPORTANT: If chain becomes loose during operation, immediately adjust as described and tighten nylon

locknut to equalize swing travel.

* This reference dimension is for a Monarch Swing Cylinder and should be checked both on RH and LH

sides before backhoe operation.

SERVICE NOTE:

At every 50 hours of backhoe operation,

replace the hardware that secures the

swing chains to the swing cylinder. Use

3/8" 16NC x 1 3/4" Grd. 8 bolts, torque to

max. of 54 ft. lbs.

0595-3176

6-5/16”

Ref

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 105 106

Comments to this Manuals

No comments

Woods BACKHOE 1050 Operator's Manual Page 65

Comments to this Manuals