Woods BACKHOE 1050 Operator's Manual download pdf (Page 43)

5. CONTROLS

The backhoe has two single lever controls plus two stabilizer control levers, located on the console control panel

directly ahead of the operator. Following is a list of the controls from left to right, with the function of each.

NOTE: You will find some functions will not work when operating simultaneous operations. If this occurs,

move lever to center and operate functions individually.

NOTE: You will hear some noise coming from the valve whenever a port relief opens. This noise is normal

during backhoe operations.

5.1. Boom & Swing:

Push lever forward, boom moves down,

away from operator.

Pull lever back, boom moves up, toward operator.

The Boom/Swing Control Lever has an added “float”

function. A detent or stop should be felt when the lever is

pushed forward to move the boom down. Pushing the lever

forward more will overcome the detent and cause the boom

to float, or move down or up freely, depending on the forces

acting on it. When the lever is released it should return to

the center, neutral position.

Move lever to the left, backhoe swings to the left.

Move lever to the right, backhoe swings to the right.

By moving the lever to one of the intermediate positions,

the boom can be swung left or right at the same time as the

boom is being raised or lowered, performing two operations

simultaneously.

LH Stabilizer RH Stabilizer

Boom & Swing Crowd & Bucket

SWING LEFT AND LOWER the boom by moving the control lever forward and to the left.

SWING LEFT AND RAISE the boom by moving the control lever back and to the left.

SWING RIGHT AND LOWER the boom by moving the control lever forward and to the right.

SWING RIGHT AND RAISE the boom by moving the control lever back and to the right.

5.2. Left Hand Stabilizer:

Push lever forward, the LH stabilizer lowers.

Pull lever backward, the LH stabilizer raises.

5.3. Right Hand Stabilizer:

Push lever forward, the RH stabilizer lowers.

Pull lever backward, the RH stabilizer raises.

5.4. Crowd & Bucket:

Push lever forward, the dipper assembly moves out, away from the operator.

Pull lever back, the dipper assembly moves in, toward the operator.

Move lever to the left, the bucket curls in.

Move lever to the right, the bucket extends out.

By moving the lever to one of the intermediate positions, the dipper assembly can be extended or retracted at the

same time as the bucket is being loaded or dumped, performing the two operations simultaneously.

EXTEND AND LOAD the bucket by moving the control lever forward and to the left.

RETRACT AND LOAD the bucket by moving the control lever back and to the left.

EXTEND AND DUMP the bucket by moving the control lever forward and to the right.

RETRACT AND DUMP the bucket by moving the control lever back and to the right.

5.1

5.2

5.3

5.4

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 105 106

Comments to this Manuals

No comments

Woods BACKHOE 1050 Operator's Manual Page 43

Comments to this Manuals