Woods BACKHOE 1050 Operator's Manual download pdf (Page 64)

12.13. Swing Pivot Service

12.13.1. The Swing Assembly King Pin Retaining Bolt

was cleaned, Shimmed, "Loctited" and torqued to 150

ft. lb. at the Factory.

12.13.2. If servicing swing bearings, always clean,

"Loctite", and reassemble using King Pin Retaining

Bolt, .075” Shim and Special Washer as shown, torque

to 150 ft. lb.

King Pin Retaining Bolt

Special Washer

12.14. Valve And Handle Linkage Service

12.14.1. Inspect console valve, handle linkage, and

hoses after every 6 months of operation.

12.14.2. Remove 4 bolts from each side of console

control panel and remove 2 bolts from each side of

valve cover plate assembly, then remove console cover

and valve cover plate assembly. Backhoe valve, handle

components, and hoses will be exposed.

12.14.3. Clean and inspect all components for damage,

replace as required. Lubricate all handle components

with a high grade of spray lubricant.

Valve Cover Plate Assembly

Console Cover

WARNING: Never adjust any pressure

reliefs in Backhoe Valve. Failure to follow

these instructions could cause damage to

Backhoe and or personal injury or death.

12.14.4. If valve handle is loose check to make sure

mounting hardware is secure. Replace any worn or

damaged control handle parts.

Check to make sure all mounting hardware is

secure

NOTE: Damaged control handle components caused by hardware loosening during operation is not

covered under warranty. If handles seem loose during operation, stop operation and service these

components.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 105 106

No comments

Woods BACKHOE 1050 Operator's Manual Page 64